Перейти к основному содержанию

Возврат к шагу #27

Редактировать с помощью Jeff Suovanen -

Правка одобрена автор Jeff Suovanen

До
После
Без изменений

Шаг Линий

[* icon_note] The logic board assembly is a tight fit, but you can make it easier to remove by inserting a spudger under the left edge and levering it up slightly.
[* icon_caution] There should be no resistance as you remove the logic board. Check all cables carefully and hold them out of the way if needed so they don't snag on the board.
[* black] Lifting from the left side, remove the logic board.
-[* icon_reminder] Check all connectors when installing board
-[* icon_reminder] Check alignment of [https://d3nevzfk7ii3be.cloudfront.net/igi/MCXjqeVth1oGdxRB.full|rubber dampers|new_window=true]

Изображение 3

Удален