Перейти к основному содержанию

Возврат к шагу #28

Редактировать с помощью Jeff Suovanen -

Правка одобрена автор Jeff Suovanen

До
После
Без изменений

Шаг Линий

[* icon_reminder] When reinstalling the logic board assembly:
[* black] Check the alignment of the rubber vibration dampers, and adjust them as needed.
- [* red] Verify that no cables get trapped under the board as you install it. Check each marked location carefully.
- [* orange] Feed the antenna cable bundle through the gap between the logic board and heat sink and make sure it lines up correctly.
+ [* red] Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.
+ [* orange] Verify that no cables get trapped under the board as you install it. Check each marked location carefully.

Изображение 3

Старая версия

Новая версия