Перейти к основному содержанию

Возврат к шагу #3

Редактировать с помощью Taylor Dixon -

Правка одобрена автор Taylor Dixon

До
После
Без изменений

Шаг Линий

-[* black] Place the flat end of an opening tool against the lower edge of the inside of the phone, as shown in the first photo.
-[* black] Carefully press upward with the opening tool to create a gap between the display and the chassis.
+[* black] Place the flat end of an opening tool against the lower edge of the inside of the phone below the battery, as shown in the first photo.
+[* black] Carefully apply pressure to the backside of the display with the opening tool to create a gap between the display and the chassis.
[* icon_note] Separating the adhesive to create the initial gap may require some force. If you are unable to perform this step, reheat the lower edge of the phone to soften the adhesive and try again.