Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Изменения в этом шаге

Редактировать с помощью Kevin Hua -

Правка одобрена автор Kevin Hua

До
После
Без изменений

Шаг Линий

[* red] To remove the back, start by removing the 10 T5 Torx screws located underneath the kickstand
[* yellow]
Now you will remove the plastic case covering the camera. The plastic case has small bezels, the small plastic snap-in pieces.
[* orange] Remove the bezel covering the camera at the top of the tablet withplastic casing using a spudger. Be patient; it takes a little timeyou will have to removework around the bezels.
[* green] Remove the 7 T5 Torx screws located under
casing because there are several small bezels along the camera bezelcasing.
[* red] To remove the back, start by removing the 10 T5 Torx screws located underneath the kickstand
[* yellow]
Now you will remove the plastic case covering the camera. The plastic case has small bezels, the small plastic snap-in pieces.
[* orange] Remove the bezel covering the camera at the top of the tablet withplastic casing using a spudger. Be patient; it takes a little timeyou will have to removework around the bezels.
[* green] Remove the 7 T5 Torx screws located under
casing because there are several small bezels along the camera bezelcasing.
[* icon_caution] Use caution removing the back cover because it is still connected to the motherboard by a ribbon cable. Use the spudger to safely detach the ribbon cable.

Изображение 1

Старая версия

Новая версия

Изображение 2

Старая версия

Новая версия

Изображение 3

Удален