Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Изменения в этом шаге

Редактировать с помощью Kevin Hua -

Правка одобрена автор Kevin Hua

До
После
Без изменений

Шаг Линий

[* red] Continue to remove the back by removing the 10 T5 (5.92 mm) Torx screws located underneath the kickstand
[* orange] Remove the 7 T5 Torx (5.87 mm) screws located under the camera casing.
[* yellow] Now you will be taking off the back plate from the main system. Read the caution below before reading on. Begin loosening the back-plate with a spudger where gaps exist (example in picture)exist.
[* icon_caution] Caution: There is an electrical ribbon connecting the back plate to the motherboard. Do not pull apart the back plate from the motherboard once you have loosen the back plate from the main system.
[* greenicon_note] Continue working your way around to each corner and loosen the snap-ons on each side. Note: You will have to patiently pryside until the back-plate openback plate comes off.
[* red] Continue to remove the back by removing the 10 T5 (5.92 mm) Torx screws located underneath the kickstand
[* orange] Remove the 7 T5 Torx (5.87 mm) screws located under the camera casing.
[* yellow] Now you will be taking off the back plate from the main system. Read the caution below before reading on. Begin loosening the back-plate with a spudger where gaps exist (example in picture)exist.
[* icon_caution] Caution: There is an electrical ribbon connecting the back plate to the motherboard. Do not pull apart the back plate from the motherboard once you have loosen the back plate from the main system.
[* greenicon_note] Continue working your way around to each corner and loosen the snap-ons on each side. Note: You will have to patiently pryside until the back-plate openback plate comes off.