Перейти к основному содержанию

Возврат к шагу #5

Редактировать с помощью Michael Bianchini -

Правка одобрена автор Michael Bianchini

До
После
Без изменений

Шаг Линий

-[* red] Continue to remove the back by removing the ten 5.92mm T5 Torx screws located underneath the kickstand
+[* red] Continue to remove the back by removing the ten 5.92mm T5 Torx screws located underneath the kickstand.
[* orange] Remove the seven 5.87mm T5 Torx screws located under the camera casing.
-[* yellow] Now you will be taking off the back plate from the main system. Begin loosening the back-plate with a plastic opening tool where gaps exist.
-[* icon_caution] There is an electrical ribbon connecting the back plate to the motherboard. Do not pull apart the back plate from the motherboard once you have loosen the back plate from the main system.
-[* icon_note] Continue working your way around to each corner and loosen the snap-ons on each side until the back plate comes off
+[* black] Take off the back plate from the main system by loosening it with a plastic opening tool where gaps exist.
+[* icon_caution] There is an electrical ribbon connecting the back plate to the motherboard. Do not pull apart the back plate from the motherboard once you have loosened the back plate from the main system.
+[* black] Continue working your way around to each corner and loosen the snap-ons on each side until the back plate comes off.

Изображение 2

Старая версия

Новая версия