Перейти к основному содержанию

Возврат к шагу #5

Редактировать с помощью pweckesser -

Правка одобрена автор pweckesser

До
После
Без изменений

Шаг Линий

-[* red] Continue to remove the back by removing the ten 5.92mm T5 Torx screws located underneath the kickstand.
-[* orange] Remove the seven 5.87mm T5 Torx screws located under the camera casing.
-[* black] Take off the back plate from the main system by loosening it with a spudger where gaps exist.
-[* icon_caution] There is an electrical ribbon connecting the back plate to the motherboard. Do not pull apart the back plate from the motherboard once you have loosened the back plate from the main system.
-[* yellow] Continue working your way around to each corner and loosen the snap-ons on each side until the back plate comes off.
+[* red] Next, remove the ten 5.92mm T5 torx screws located underneath the kickstand.
+[* orange] Remove the seven 5.87mm T5 torx screws located under the camera casing.
+[* black] Disconnect the rear cover from the main shell of the system by loosening it with a spudger where the gaps exist.
+[* icon_caution] There is an electrical ribbon connecting the rear cover to the motherboard. Do not pull apart the rear cover from the motherboard once you have loosened the rear cover from the main system.
+[* yellow] Continue working your way around to each corner and loosen the snap-ons on each side until the rear cover comes off.