Перейти к основному содержанию

Возврат к шагу #3

Редактировать с помощью Julian Sanchez -

Правка одобрена автор Julian Sanchez

До
После
Без изменений

Шаг Линий

-[* black] Grab a suction cup tool and place it near the bottom of the phone.
-[* black] Pull up on the suction cup to slightly lift the LCD Panel from the body of the phone.
-[* black] Starting from the bottom, slide in a plastic opening tool between the gap of the LCD and the phone.
-[* black] Using a combination of the plastic opening tool and picks, slide around the gaps to unhook the clips, unhinging the panel from the body of the phone.
-[* black] Flip the phone screen towards the bottom of the device and lay the screen facing down.
+[* red] Grab a suction cup tool and place it near the bottom of the phone.
+[* orange] Pull up on the suction cup to slightly lift the LCD Panel from the body of the phone.
+[* yellow] Starting from the bottom, slide in a plastic opening tool between the gap of the LCD and the phone.
+[* green] Using a combination of the plastic opening tool and picks, slide around the gaps to unhook the clips, unhinging the panel from the body of the phone.
+[* light_blue] Flip the phone screen towards the bottom of the device and lay the screen facing down.
[* icon_note] Note: The ribbon cable is in the middle of the panel, thus there is no need to be cautious about snagging a ribbon cable

Изображение 1

Старая версия

Новая версия

Изображение 2

Старая версия

Новая версия

Изображение 3

Старая версия

Новая версия