Перейти к основному содержанию

Возврат к шагу #3

Редактировать с помощью Victor Sanchez Gutierrez -

Правка одобрена автор Victor Sanchez Gutierrez

До
После
Без изменений

Шаг Линий

-[* black] Grab a suction cup tool and place it near the bottom of the phone
-[* black] Pulling up on the suction cup to slightly lift the LCD Panel from the body of the phone
-[* black] Using a combination of the plastic opening tool and picks, slide around the gaps to unhook the clips, releasing the panel from the body of the phone.
+[* black] Grab a suction cup tool and place it near the bottom of the phone.
+[* black] Pull up on the suction cup to slightly lift the LCD Panel from the body of the phone.
+[* black] Starting from the bottom, slide in a plastic opening tool between the gap of the LCD and the phone.
+[* black] Using a combination of the plastic opening tool and picks, slide around the gaps to unhook the clips, unhinging the panel from the body of the phone.
[* icon_note] Note: The ribbon cable is in the middle of the panel, thus there is no need to be cautious about snagging a ribbon cable