Перейти к основному содержанию

Изменения в этом шаге

Редактировать с помощью Adam O'Camb -

Правка одобрена автор Adam O'Camb

До
После
Без изменений

Шаг Линий

+[* icon_note] The rear half of the enclosure is bolted to the handle support, so the front half will be removed first.
+[* black] Pull the front half of the enclosure straight away from the rear half to separate the enclosure.
+ [* icon_note] The interlock assembly is attached to the rear half of the enclosure, but will likely stick to the posts on the front half. If this happens, do not fully remove the front half yet.
+ [* black] If the interlock assembly is stuck to the front half of the enclosure, pull it straight off of its posts on the front half and gently push it onto the two posts near the top of the rear half.
[* black] Remove the front half of the handle enclosure.
-[* icon_note] The interlock assembly will need to remain in place, so hold onto it to prevent it from falling out as you remove the enclosure.

Изображение 1

Старая версия

Новая версия

Изображение 2

Старая версия

Новая версия

Изображение 3

Старая версия

Новая версия