Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Изменения в этом шаге

Редактировать с помощью bushing -

На одобрении

До
После
Без изменений

Шаг Линий

[* blackred] Disconnect the 3 wireswhite power connector from the main board by gently prying it straight up, away from the battery's printed circuit board(PCB)board. Do not attempt to pull it out to the side.
[* red] To disconnectblue] Remove the wires, stick a flat tool (plastic spudger, DSi opening tool, etc.) underneathLED assembly from the colored componentcase by lifting it out of the connector (i.e. brown or white) and pop it upcase.
[* orange] Disconnect the three ribbon cables by using an iPod opening tool to pry the black plastic latch piece up, then pull the cable out. It should not require much force
.
[* blackred] Disconnect the 3 wireswhite power connector from the main board by gently prying it straight up, away from the battery's printed circuit board(PCB)board. Do not attempt to pull it out to the side.
[* red] To disconnectblue] Remove the wires, stick a flat tool (plastic spudger, DSi opening tool, etc.) underneathLED assembly from the colored componentcase by lifting it out of the connector (i.e. brown or white) and pop it upcase.
[* orange] Disconnect the three ribbon cables by using an iPod opening tool to pry the black plastic latch piece up, then pull the cable out. It should not require much force
.

Изображение 1

Старая версия

Новая версия