Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Изменения в этом шаге

Редактировать с помощью bushing -

На одобрении

До
После
Без изменений

Шаг Линий

[* red] Disconnect the white power connector from the main board by gently prying it straight up, away from the board. Do not attempt to pull it out to the side.
[* blue] Remove the LED assembly from the case by lifting it out of the case.
[* orange] Disconnect the three ribbon cables by using an iPoda plastic opening tool to pry the black plastic latch piece up, then pull the cable out. It should not require much force.
[* orange] Disconnect the three ribbon cables by using an iPoda plastic opening tool to pry the black plastic latch piece up, then pull the cable out. It should not require much force.