Перейти к основному содержанию

Возврат к шагу #6

Редактировать с помощью Kyle Smith -

Правка одобрена автор Kyle Smith

До
После
Без изменений

Шаг Линий

[title] Disconnect the display press connectors
[* black] Use the pointed end of a spudger to disconnect the digitizer press connector from the logic board.
- [* icon_caution] Take care to pry only under the edge of the connector to prevent damaging the socket itself and surrounding components.
[* icon_reminder] To re-attach [guide|25629|press connectors|stepid=70308|new_window=true] like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage.