Перейти к основному содержанию

Возврат к шагу #5

Отредактированно Kyle Smith -

Правка одобрена автор Kyle Smith

До
После
Без изменений

Шаг Линий

+[* black] Grab the bottom right pull-tab with your fingers and slowly pull it away from the battery, toward the bottom of the iPhone.
+ [* black] Pull hard enough to maintain tension on the strip, but don't force it. Give it plenty of time to stretch and un-stick from under the battery.
+ [* black] Don't press down on the battery. Hold the iPhone firmly by its sides.
+ [* black] Keep the strip flat and unwrinkled. Try to pull evenly on the whole strip, rather than pulling mainly in the middle or on one side.
+ [* black] Pull at a low angle so the strip doesn't snag on the edge of the battery.
+[* black] If the adhesive strip breaks off, try to retrieve it using your fingers or blunt tweezers, and continue pulling—but do not pry under the battery.
+[* icon_caution] If any of the adhesive strips break off underneath the battery and can't be retrieved, try to remove the other strips, and then proceed as instructed below.

Изображение 1

Нет предыдущего изображения

Добавлено

Изображение 2

Нет предыдущего изображения

Добавлено

Изображение 3

Нет предыдущего изображения

Добавлено