Возврат к шагу #1
Отредактированно Liam Kandell -
Правка одобрена автор Liam Kandell
- До
- После
- Без изменений
Шаг Линий
| - | [title] |
|---|---|
| - | [* black] The recycled plastic front cover is press |
| + | [title] Front Enclosure |
| + | [* black] The recycled plastic front cover is press-fit onto the device body and connected by a flex cable that can be easily disconnected by hand. |
| [* black] Mounted on the underside of the outer front enclosure are the touch sensors along with a small daughter board affixed by three Torx IP screws. | |
| - | [* black] Press a simple pick into the seam between the front and back housing, and pry gently along the seam |
| + | [* black] Press a simple pick into the seam between the front and back housing, and pry gently along the seam separating the enclosure covers from the body. If the front cover is difficult to pry off, you might need to insert a flathead screwdriver into the seam and rotate to lift the cover off of the body. |
| [* black] Once the front enclosure loosens a little, it should easily start to “pop” off. Once off, carefully flip up the front enclosure to access the flex cable. Disconnect the cable to free the front enclosure. |