| - | [* black] When assemblying, these might be nice to know. When placing the big rumble motor's just place the plectrum inside it first so it just slides in. |
|---|
| - | [* black] When the daugtherboard is placed back in the chassis, check if all the buttons work(exepct B that goes to the mother). |
|---|
| - | [* black] (It took me second to find my Y was dislodged beacuse the controller was resting on it, that meant i couldn't press it and could't pull the RT all the wat back so i had to go back). |
|---|
| - | [* black] When putting back the D-pad ring make sure the top is sitting deep enough or you could run into trouble. |
|---|
| - | [* black] ***Please*** when you are almost done and only need to put the side plates (step 2) check ***++before++*** if everything works you can easly do this using this link https://gamepad-tester.com/ |
|---|
| + | [* icon_reminder] When assemblying, these might be nice to know. When placing the big rumble motor's just place the plectrum inside it first so it just slides in. |
|---|
| + | [* icon_reminder] When the daugtherboard is placed back in the chassis, check if all the buttons work(exepct B that goes to the mother). |
|---|
| + | [* icon_note] (It took me second to find my Y was dislodged beacuse the controller was resting on it, that meant i couldn't press it and could't pull the RT all the wat back so i had to go back). |
|---|
| + | [* icon_reminder] When putting back the D-pad ring make sure the top is sitting deep enough or you could run into trouble. |
|---|
| + | [* icon_caution] ***Please*** when you are almost done and only need to put the side plates (step 2) check ***++before++*** if everything works you can easly do this using this link https://gamepad-tester.com/ |
|---|