Возврат к шагу #12
Отредактированно Ryn S -
Правка одобрена автор Repair Skeleton
- До
- После
- Без изменений
Шаг Линий
| - | [title] Tips for |
|---|---|
| - | [* icon_reminder] When |
| + | [title] Tips for assembly |
| + | [* icon_reminder] When assembling, these might be nice to know. When placing the big rumble motors, place the plectrum in first so it just slides in. |
| [* icon_reminder] When the daugtherboard is placed back in the chassis, check if all the buttons work(exepct B that goes to the mother). | |
| - | [* icon_note] (It took me second to find my Y was dislodged |
| - | [* icon_reminder] When putting back the D-pad ring make sure the top is sitting deep enough or you could run into trouble. |
| + | [* icon_note] (It took me a second to find that my Y was dislodged because the controller was resting on it, that meant I couldn't press it and couldn't pull the RT all the way down, so I had to go back some steps). |
| + | [* icon_reminder] When putting back the D-pad ring, make sure the top is sitting deep enough or you could run into trouble. |
| [* icon_reminder] When placing the wires back for the trigger rumble motors... just put on some good music and try to keep you patience. | |
| - | [* icon_caution] ***Please*** when you are almost done and only need to put the side plates (step 2) check ***++before++*** if everything works |
| + | [* icon_caution] ***Please*** when you are almost done and only need to put the side plates (step 2) check ***++before++*** finishing if everything works. You can easily do this using this link https://gamepad-tester.com/ |