Изменения в этом шаге
Отредактированно Manuel Haeussermann -
Правка одобрена автор Manuel Haeussermann
- До
- После
- Без изменений
Шаг Линий
| [title] Lift the display slightly | |
| + | [* black] If you're using a single suction handle, apply it to the bottom edge of the phone, while avoiding the very edge of the glass. |
| [* black] Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case. | |
| [* black] Insert an opening pick into the gap. | |
| [* icon_note] The watertight adhesive holding the display in place is very strong; creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, apply more heat, and gently rock the screen up and down to weaken the adhesive until you create enough of a gap to insert your opening pick. |