Перейти к основному содержанию

Changes to Step #14

Edit by Adam O'Camb

Правка одобрена автор Adam O'Camb

Удален
Добавлено
Без изменений

Шаг Линий

[* black] Peelicon_note] ''At this point it's a good idea to test your repair, in order to make sure your iMac works properly before you seal it back up. Follow the next three steps to temporarily reconnect the display cables and boot up your iMac prior to pulling the protective film off the adhesive strips.''
[* black] If you've already verified that your iMac is working correctly
and removeare ready to seal it up, skip to Step 16.
[* black] Gently insert
the backing from strips 15display data connector into its socket on the logic board. Be sure to press it straight into the socket, and 14insert it completely.
[* black] Flip the display data connector lock down onto the socket.
[* black] Insert the display power connector into its socket
on the displaylogic board.
[* black] Peelicon_note] ''At this point it's a good idea to test your repair, in order to make sure your iMac works properly before you seal it back up. Follow the next three steps to temporarily reconnect the display cables and boot up your iMac prior to pulling the protective film off the adhesive strips.''
[* black] If you've already verified that your iMac is working correctly
and removeare ready to seal it up, skip to Step 16.
[* black] Gently insert
the backing from strips 15display data connector into its socket on the logic board. Be sure to press it straight into the socket, and 14insert it completely.
[* black] Flip the display data connector lock down onto the socket.
[* black] Insert the display power connector into its socket
on the displaylogic board.

Image 1

Старая версия

Новая версия

Image 2

Старая версия

Новая версия

Image 3

Нет предыдущего изображения

Добавлено