Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Возврат к шагу #4

Редактировать с помощью Schwarzstein -

Правка одобрена автор Schwarzstein

До
После
Без изменений

Шаг Линий

[* black] The Botton above the lowest drawer has a heating foil. Unscrew on the back a PH2 Head andscrew. Also is a PH2 in front left at the Filter's place. Now carefully lift the Bottom. Take out the Styroporfoam-Element. Then open the Plasticbag which contains the Connector for the Heating. You should cut-off the MainsAC-Mains before unplugging this Connector.
[* black] The Botton above the lowest drawer has a heating foil. Unscrew on the back a PH2 Head andscrew. Also is a PH2 in front left at the Filter's place. Now carefully lift the Bottom. Take out the Styroporfoam-Element. Then open the Plasticbag which contains the Connector for the Heating. You should cut-off the MainsAC-Mains before unplugging this Connector.
[* black] Now you can remove the Heating; Top of the Bottom.
[* black] OPenOpen the secondshorter PH2 Screw to release the LED-Light on the Bottom. UnplugThat's necessary because with the Wiringwires at it you could not pull out the chassis of the Bottom.
[* black] Now you can pull out the Chassis of the lower Bottom, use PLastictoola Plastictool for the Clipse. Pull off the holder of the Waterfilter.
[* black] OPenOpen the secondshorter PH2 Screw to release the LED-Light on the Bottom. UnplugThat's necessary because with the Wiringwires at it you could not pull out the chassis of the Bottom.
[* black] Now you can pull out the Chassis of the lower Bottom, use PLastictoola Plastictool for the Clipse. Pull off the holder of the Waterfilter.