Перейти к основному содержанию

Возврат к шагу #18

Редактировать с помощью Walter Galan -

Правка одобрена автор Walter Galan

До
После
Без изменений

Шаг Линий

-[* black] With the cards inserted as shown near the corners, gently twist the cards to increase the gap between display and case.
-[* black] If there are any sections that seem to stick and won't separate, stop twisting and use one of the cards to cut the adhesive in the problem area.
+[* black] With both plastic cards inserted as shown near the corners, gently twist the cards sideways to increase the gap between display and case.
+[* icon_note] If there are any sections that seem to stick and won't separate, stop twisting and use one of the cards to cut the remaining adhesive.
[* black] Begin to lift the top of the display up from the frame.
-[* icon_caution] Only lift the display a few inches—it is still attached to the iMac by data and power cables.
+[* icon_caution] Only lift the display a few inches—the display data and power cables are still connected to the logic board.