Возврат к шагу #6
Отредактированно Curt Reitenbach -
Правка одобрена автор Curt Reitenbach
- До
- После
- Без изменений
Шаг Линий
| - | [* black] Set up the multimeter: |
|---|---|
| [* black] Connect red (positive) probe to the Voltage and Resistance Socket. | |
| [* black] Connect black (negative) probe to the Common/Ground Socket. | |
| [* black] Turn knob of multimeter to the Diode and Capacitance Test Setting. | |
| [* icon_note] As shown in the photo, the multimeter will read "OL" if the steps above have been followed properly. | |
| [* black] Touch the tip of the probes together to verify the multimeter is functioning properly. | |
| [* icon_note] Upon completing this step above, the multimeter should read a number less than 1. The photo in the guide does not depict this. |