Перейти к основному содержанию

Возврат к шагу #2

Редактировать с помощью Phillip Takahashi -

На одобрении

До
После
Без изменений

Шаг Линий

-[* icon_reminder] The camera board has a small heat sink with thermal putty applied to its surface. Be sure the putty is evenly distributed on the heat sink before reinstallation.
+[* icon_reminder] The camera board has a small heat sink with thermal paste applied to its surface. Be sure the putty is evenly distributed on the heat sink before reinstallation.
[* black] Slightly lift the camera board out of the outer case, being careful not to disturb the aluminum tape securing the camera cable to the outer case.
[* black] Disconnect the camera cable by pulling its connector away from the socket on the camera board.