История iBook G4 12" 800 MHz-1.2 GHz Heat Sink Replacement Шага #5

Возврат к шагу #5

Отредактированно iRobot - 20 апр 2010 г.

+	[* icon_note] The 3.5 mm Phillips screw indicated below with a red circle may be absent in some models.
+	[* black] Remove the following 5 screws and 3 nuts from the heat sink:
+	[* red] One 3.5 mm Phillips from the lower left corner of the heat sink.
+	[* orange] Three 6 mm Phillips from around the fan.
+	[* yellow] One 7.5 mm Phillips at the top right corner of the heat sink.
+	[* green] One 4 mm nut from the side of the heat sink.
+	[* blue] Two 4 mm screw nuts with attached springs from either side of the heat sink.

Изображение 1

Нет предыдущего изображения

Добавлено