История HP All-in-one PC Model 24 Motherboard Replacement Шага #10 - iFixit

Возврат к шагу #10

Отредактированно Drake Watters - 21 ноя 2024 г.

Правка одобрена автор Drake Watters

: До
: После
: Без изменений

Шаг Линий

	[title] Removing the CPU Cooling Fan
	[* blue] *Disconnect the Fan's Power Cable*: Locate the fan's power cable connected to the motherboard. Gently unplug the cable by pulling on the wire very close to the connector perpendicular to the board.
	[* red] *Unscrew the Fan*: Use a screwdriver to remove the screws that secure the cooling fan in place. There are only three screws.
	[* icon_note] *Note*: Keep the screws in a safe place for reassembly.
	[* black] *Remove the Fan*: Lift the cooling fan away from the CPU and motherboard.
	[* orange] *Cooling bar system*: Do not remove this, yet.
-	[* icon_caution] The device directly behind the fan is the cooling bar system. This is attached to the CPU on the motherboard. Make sure not to damage the system.
+	[* icon_caution] *WARNING*: The device directly behind the fan is the cooling bar system. This is attached to the CPU on the motherboard. Make sure not to damage the system.