Возврат к шагу #7
Отредактированно idmadj -
Правка отклонена автор Jeff Suovanen
- До
- После
- Без изменений
Шаг Линий
| [* icon_caution] The front panel is attached with clips, and there are several ribbon cables connecting it to the rest of the phone. Your goal here is to release the clips and ***open the phone only enough to disconnect the cables***. Go slowly and carefully to avoid damage. | |
| + | [* icon_caution] The suction cup is only used to create minimal tension on the panel, allowing a plastic opening tool to be inserted between the panel and body. ***Do not attempt to open the device by pulling on the suction cup.*** Separating the panel by pulling on the suction cup will damage the home button cable, permanently disabling Touch ID. |
| [* icon_note] Make sure the suction cup is firmly attached to the front panel assembly near the home button. | |
| - | [* black] While holding the iPhone down with one hand, pull up on the suction cup to slightly separate the home button end of the front panel from the rear case. |
| - | [* black] With a plastic opening tool, gently pry the edges of the rear case down, away from the front panel assembly, while you pull up with the suction cup. |
| - | [* icon_caution] Take your time and apply firm, constant force. The 5s front panel assembly is a much tighter fit than most devices. |
| + | [* black] While holding the iPhone down with one hand, gently pull up on the suction cup until there is just enough space to insert the tip of the plastic opening tool. You may need someone to insert the tool while you maintain tension. |
| + | [* black] With the plastic opening tool, gently pry the edges of the rear case down, away from the front panel assembly. |