Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Возврат к шагу #17

Редактировать с помощью iGuys -

Правка отклонена автор Sam Goldheart

До
После
Без изменений

Шаг Линий

[* black] Remove the following screws securing the front panel assembly cable bracket to the logic board:
[* red] Two 1.7 mm Phillips #000 screws
[* orange] One 1.2 mm Phillips #000 screw
[* yellow] One 1.3 mm Phillips #000 screw
[* icon_note] This 1.3 mm screw tends to not be attracted to a magnetized screwdriver. Take care not to lose it when removing.
[* icon_caution] It is very important the screws go back nto the same holes that they came out of. Failure to do so will very likely cause permanent damage to the logic board. The bottom right hole is particularly susceptible to damage if one of the longer screws is used in this hole.