Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #2

Редактировать с помощью Griffin Paul -

Правка одобрена автор Griffin Paul

До
После
Без изменений

Шаг Линий

[* black] Starting at the wide base of the triangular sections, use the 10 mm nuts and bolts to attach two solar panel plates together. First hand tighten each bolt/nut pair, then secure them with your two 10 mm wrenches.
[* red] On the way to the center, DO NOT install a nut and bolt in the '''THIRD TO LAST''' drill hole. This is where you will attach the Pipe Ring BracketsBracket is attached later on.
[* red] On the way to the center, DO NOT install a nut and bolt in the '''THIRD TO LAST''' drill hole. This is where you will attach the Pipe Ring BracketsBracket is attached later on.