Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #2

Редактировать с помощью Griffin Paul -

Правка одобрена автор Griffin Paul

До
После
Без изменений

Шаг Линий

[* black] Starting at the wide base of the triangular sections, useUse the 10 mm nuts and bolts to attach the two plates together. First, hand thread each bolt/nut pair, then use two 10 mm wrenches secure them.
[* red] DO NOT install a nut and bolt in the '''THIRD TO LAST''' holeTHIRD''' hole from the center (pointed end of the section). This is where the Pipe Ring Bracket is attached later on.
[* black] Starting at the wide base of the triangular sections, useUse the 10 mm nuts and bolts to attach the two plates together. First, hand thread each bolt/nut pair, then use two 10 mm wrenches secure them.
[* red] DO NOT install a nut and bolt in the '''THIRD TO LAST''' holeTHIRD''' hole from the center (pointed end of the section). This is where the Pipe Ring Bracket is attached later on.