Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #3

Редактировать с помощью Kurt Zeller -

Правка одобрена автор Kurt Zeller

До
После
Без изменений

Шаг Линий

[* icon_note] After firmly fastening the two sections together, return to the third hole which was left empty. In addition to a nut and bolt, you will also need a Pipe Ring Bracketpipe ring bracket.
[* icon_note] After firmly fastening the two sections together, return to the third hole which was left empty. In addition to a nut and bolt, you will also need a Pipe Ring Bracketpipe ring bracket.
[* black] Install the 10mm nut/bolt combo again, this time with the bolt also passing through the single holed side of the bracket. Hand tread and use 10mm wrenches to tighten.
[* icon_note] Be sure the bracket is '''NOT''' installed between the lipsedges of the two Reflective Dish sections, but ondish sections.
[* icon_note] The direction
the outsidebracket faces does not matter.
[* icon_note] Be sure the bracket is '''NOT''' installed between the lipsedges of the two Reflective Dish sections, but ondish sections.
[* icon_note] The direction
the outsidebracket faces does not matter.