Перейти к основному содержанию

Changes to Step #1

Edit by Daniel Pawluk

На одобрении

Удален
Добавлено
Без изменений

Шаг Линий

[* black] Carefully note the brown colored locking bar that shims the ribbon cable in it's housing so it cannot slip.
[*
black] Using a nylon stick (or some other ESD safe probe) ''gently'' push both sides of the tweezers, gently pulllocking bar up.
[* black] Now
the ribbon fromcable should move freely. A careful prod using your nylon spudger should be able to free the cable. ''++This should '''barely''' require any force at all++''. Otherwise, check that the logic boardlocking bar is fully disengaged.
[* black] Carefully note the brown colored locking bar that shims the ribbon cable in it's housing so it cannot slip.
[*
black] Using a nylon stick (or some other ESD safe probe) ''gently'' push both sides of the tweezers, gently pulllocking bar up.
[* black] Now
the ribbon fromcable should move freely. A careful prod using your nylon spudger should be able to free the cable. ''++This should '''barely''' require any force at all++''. Otherwise, check that the logic boardlocking bar is fully disengaged.