Перейти к основному содержанию

Возврат к шагу #2

Редактировать с помощью Carsten Frauenheim -

Правка одобрена автор Carsten Frauenheim

До
После
Без изменений

Шаг Линий

-[* icon_note] If you're installing a new front panel assembly, it may need the following preparation:
- [* red] Peel the plastic strips covering the adhesive around the perimeter of the front panel assembly.
- [* orange] Remove the small piece of adhesive backing from the digitizer cable.
-[* black] Make sure all copper is covered on the new replacement screen as once fitted without this the screen will move randomly.
+[title] Front panel preparation
+[* icon_reminder] This is a good time to power on your iPad and test all functions before you seal the display in place. Be sure to power your iPad back down completely before you continue.
+[* icon_note] If you're installing a new front panel assembly, it ***may*** need the following preparation:
+ [* red] Peel the large clear plastic liner off of the inside of the glass.
+ [* orange] Peel any blue plastic backings covering the adhesive around the perimeter of the front panel assembly.
+ [* icon_caution] Once removed, the adhesive strips will be exposed. Don't remove these backings until you're ready to install the front panel assembly.
+ [* yellow] ***Don't remove any copper coverings from the outlined region***, such as yellow kapton tape or black electrical tape.
+[* black] Ensure the glass panel is free of fingerprints and grime before installing it on your device.

Изображение 1

Старая версия

Новая версия

Изображение 2

Старая версия

Новая версия