Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #1

Редактировать с помощью Randy Fromm -

Правка одобрена автор Randy Fromm

До
После
Без изменений

Шаг Линий

[* black] FIRST IMAGE: Remove the power supply. Align the kettle as shown, with the handle to your right. Use the 7/32" nut driver to remove the 7/32" nut from the stud clockwise from where the power supply was attached.
[* black] Use tweezers to remove the split-ring lock washer located under the nut.
[* black] SECOND IMAGE: Roll the kettle over so the handle is now on your left. Use the 7/32" nut driver to remove the 7/32" nut from the final stud, now anti-clockwisecounter-clockwise from where the power supply was attached.
[* black] SECOND IMAGE: Roll the kettle over so the handle is now on your left. Use the 7/32" nut driver to remove the 7/32" nut from the final stud, now anti-clockwisecounter-clockwise from where the power supply was attached.
[* black] Use tweezers to remove the split-ring lock washer located under the nut.