Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #3

Редактировать с помощью Tyler Vincent -

Правка одобрена автор Tyler Vincent

До
После
Без изменений

Шаг Линий

[* blackred] Using side cutters, cut the red and black wires connecting the battery to the printed circuit board just after the shrink wrap tubing.
[* blackred] Using side cutters, cut the red and black wires connecting the battery to the printed circuit board just after the shrink wrap tubing.
[* black] Strip the ends of the wires attached to the printed circuit board 1/4 inch above the ends of the cut wires.
[* black] Solder the new battery to the stripped wires attached to the printed circuit board.
[* black] Wrap the newly soldered connections with electrical tape.