Перейти к основному содержанию

Changes to Step #4

Edit by Laura Kawashiri

Правка одобрена автор Laura Kawashiri

Удален
Добавлено
Без изменений

Шаг Линий

[* red] Remove all the screws on the perimeter of the speaker. Use locking pliers to remove the nuts. There are 7 totaleight bolts holding the speaker in place.
[* black] Once removed you can now insertPull the old speaker off of the board and insert the new speaker the same way you removed the old one.
[* icon_noteorange] ''When tightening the nuts back down on the bolts, be sure to tighten them by alternating, working in diagonals. (i.e. once you tighten one down go diagonal from it and work on the next one.''
[* black] Repeat with the other speaker if necessary.
[* black] Follow the steps in reverse order to reassemble the device.
[* red] Remove all the screws on the perimeter of the speaker. Use locking pliers to remove the nuts. There are 7 totaleight bolts holding the speaker in place.
[* black] Once removed you can now insertPull the old speaker off of the board and insert the new speaker the same way you removed the old one.
[* icon_noteorange] ''When tightening the nuts back down on the bolts, be sure to tighten them by alternating, working in diagonals. (i.e. once you tighten one down go diagonal from it and work on the next one.''
[* black] Repeat with the other speaker if necessary.
[* black] Follow the steps in reverse order to reassemble the device.

Image 2

Старая версия

Новая версия