Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Возврат к шагу #5

Редактировать с помощью Sam Goldheart -

Правка одобрена автор Sam Goldheart

До
После
Без изменений

Шаг Линий

[* black] Remove the following screws securing the logic board to the rear case:
[* red] Two 2.3 mm Phillips screws
[* orange] Three 2.7 mm standoff screws
[* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver.
[* icon_reminder] Reassembly hint: whenWhen putting the standoffs back in, it helps to use the tip of a spudger like a screwdriver to get them started.
[* icon_reminder] Reassembly hint: whenWhen putting the standoffs back in, it helps to use the tip of a spudger like a screwdriver to get them started.