Перейти к основному содержанию

Возврат к шагу #10

Редактировать с помощью oldturkey03 -

Правка одобрена автор oldturkey03

До
После
Без изменений

Шаг Линий

-[* black] Insert wisdom here.
+[* red] First to remove the mic cable. All connections in this headset are soldered. If possible, slide the heat shrink off the soldered connections to separate them with a soldering iron
+ [* blue] these are the cord clips holding which prevent the cables from being pulled out of the dome.
+[* black] The connections where the heat shrink tubing can not be removed, are cut with a pair of pliers.
+[* blue] With the mic cable connected, pull the cable inside the dome to gain easy access to the cord clip

Изображение 1

Старая версия

Новая версия

Изображение 3

Старая версия

Новая версия