Перейти к основному содержанию

Возврат к шагу #5

Редактировать с помощью iRobot -

На одобрении

До
После
Без изменений

Шаг Линий

-[* black] Use your thumbs to slide the RJ-11 telephone jack away from the sound card in the same direction you would if you were disconnecting the phone cable. The jack has two slots that cup the board so make sure that when you apply pressure to remove from the board you are pushing parallel to the board.
-[* black] This is your chance to get out some aggression, as the jack will most likely be very tight and requires a good deal of force to remove. Don't get carried away though - don't hold onto the power connector and don't put too much actual force on the card itself.
+[* black] Use your thumbs to slide the RJ-11 board away from the sound card in the same direction you would disconnect a cable. This is your chance to get out some aggression, as the board will most likely be very tight and requires a good deal of force to remove. Don't get carried away though - don't hold onto the power connector and don't put too much actual force on the card itself.