Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #22

Редактировать с помощью Andrew Optimus Goldheart -

Правка одобрена автор Andrew Optimus Goldheart

До
После
Без изменений

Шаг Линий

[* icon_note] There are six piecesIn the next steps, you will use an iOpener to apply heat to the rear case of strongthe iPad to soften adhesive tape holding the logic board onto the rear casein place.
[* black] Make sure you pryred] The adhesive is in the logic board offform of each piecesix pieces of tape. Use these imagesblack foam tape—refer to this step as a guideyou work at heating and prying to check that all adhesive has been severedkeep track of where each piece is located.
[* icon_note] There are six piecesIn the next steps, you will use an iOpener to apply heat to the rear case of strongthe iPad to soften adhesive tape holding the logic board onto the rear casein place.
[* black] Make sure you pryred] The adhesive is in the logic board offform of each piecesix pieces of tape. Use these imagesblack foam tape—refer to this step as a guideyou work at heating and prying to check that all adhesive has been severedkeep track of where each piece is located.

Изображение 1

Старая версия

Новая версия

Изображение 2

Старая версия

Новая версия

Изображение 3

Старая версия

Новая версия