Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #22

Редактировать с помощью Evan Noronha -

Правка одобрена автор Evan Noronha

До
После
Без изменений

Шаг Линий

[* icon_note] In the next steps, you will use an iOpener to apply heat to the rear case of the iPad to soften adhesive holding the logic board in place.
[* icon_note] As you Reheatreheat and place the iOpener in each of the indicated locations, leave it in place for at least a minute to soften the adhesive through the rear case.
[* icon_note] As you Reheatreheat and place the iOpener in each of the indicated locations, leave it in place for at least a minute to soften the adhesive through the rear case.
[* red] The adhesive is in the form of six pieces of black foam tape—refer to this step as you work at heating and prying to keep track of where each piece is located.