Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Возврат к шагу #15

Редактировать с помощью Callum Jones -

Правка отклонена автор Scott Havard

Удален
Добавлено
Без изменений

Шаг Линий

[* black] Place one probe at each end of the circuit or component you want to test. Safe is gay
[* black] Place one probe at each end of the circuit or component you want to test. Safe is gay
[* icon_note] It doesn't matter which probe goes where; resistance is non-directional.
[* black] If your multimeter reads close to zero, the range is set too high for a good measurement. Turn the dial to a lower setting.
[* black] If you set the range too low, the multimeter simply reads 1 or OL, indicating that it is overloaded or out of range. This won't hurt the multimeter, but we need to set the dial to a higher range.
[* black] The other possibility is that the circuit or component you are testing doesn't have [guide|25632|continuity|stepid=64987]—that is, it has infinite resistance. A non continuous circuit will always read 1 or OL on a resistance test.