Возврат к шагу #16
Отредактированно Jeff Suovanen -
Правка одобрена автор Jeff Suovanen
- До
- После
- Без изменений
Шаг Линий
| [* black] Remove the battery. | |
| [* icon_reminder] Before installing your new battery, remove all the old adhesive from the MacBook Pro's case. | |
| [* black] With a little luck, you can slowly pull out each strip of adhesive with your fingers. | |
| [* black] Otherwise, soak each section of adhesive with a bit of adhesive remover for 2-3 minutes, and then scrape it out with an opening pick or one of the other tools in your kit. This can take quite a bit of work, so be patient. | |
| [* black] Mop up any remaining adhesive remover and give your MacBook Pro a few minutes to air dry. | |
| - | [* icon_reminder] The replacement battery included in your iFixit kit comes with adhesive pre-installed. Test the battery's fit and |
| + | [* icon_reminder] The replacement battery included in your iFixit kit comes with adhesive pre-installed. Test the battery's fit and alignment carefully before peeling off the film covering the adhesive, and then press each cell firmly into place. |
| [* black] Calibrate your battery before using it: allow it to drain overnight, then charge it to 100% and drain it again until your MacBook Pro shuts down automatically. Charge it again and use it normally. | |
| [* icon_caution] If you notice any unusual behavior or problems after installing your new battery, you may need to [https://support.apple.com/en-gb/HT201295|reset your MacBook Pro's SMC|new_window=true]. |