Перейти к основному содержанию

Изменения к шагу №1

Отредактированно Richdave -

На одобрении

Удален
Добавлено
Без изменений

Шаг Линий

[* black] After removing the front bezel, you need to remove the 8ea 12mm T8 screws around the perimeter of the LCD
[* icon_caution] Rotate the iMac so the TOP EDGE is facing you and GENTLY lift the LCD up about 75mm (3in) and prop up the LCD with something NON CONDUCTIVE.
[* icon_caution] Lifting the LCD in this way exposes the rear of the PSUPSU to allow access to the PSU connector. When powered upthe imac is connected to the mains ('''even if switched OFF''') there is MAINS VOLTAGE'''MAINS VOLTAGE''' on this board
[* icon_caution] Lifting the LCD in this way exposes the rear of the PSUPSU to allow access to the PSU connector. When powered upthe imac is connected to the mains ('''even if switched OFF''') there is MAINS VOLTAGE'''MAINS VOLTAGE''' on this board