Перейти к основному содержанию

Возврат к шагу #3

Редактировать с помощью Arthur Shi -

Правка одобрена автор Arthur Shi

До
После
Без изменений

Шаг Линий

[* red] Remove the two 7.2 mm T10 Torx screws securing the power supply to the rear enclosure.
[* icon_note] In newer model iMacs these are 7.2 mm T8 Torx screws.
- [* icon_note] When reassembling - make sure you have positioned the power button wire so it is not trapped below the board.
+ [* icon_reminder] During reassembly, be careful not to trap the power button wire behind the board.