Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Возврат к шагу #5

Редактировать с помощью Alex Scott -

Правка одобрена автор David Hodson

Удален
Добавлено
Без изменений

Шаг Линий

[* black] A sticky adhesive holds the speakers in place in addition to the screws. The speakers will likely be reluctant to detach from the panel due to this cement.
[* icon_reminder] Before removing the speaker, unplug the black and red wires from the circuit board.
[*
black] To overcome the adhesive and remove the speakers, place the screw driver in the needle hole ofin the speaker mesh and pry out. This should be all that needs to be done to popout, using the raised metal lip in the center of the speaker outfor leverage.
[* black] A good amount of force may be necessary to completely overcome the adhesive. NOTE. The tweezers or needle nose pliers canmay be used in place of the screw driver.
[* black] Unplug the black and red speaker wires from the white outlet near the middle of the panel (purple marker) by gently pulling on the wires.
[* icon_reminder] Before removing the speaker, unplug the black and red wires from the circuit board.
[*
black] To overcome the adhesive and remove the speakers, place the screw driver in the needle hole ofin the speaker mesh and pry out. This should be all that needs to be done to popout, using the raised metal lip in the center of the speaker outfor leverage.
[* black] A good amount of force may be necessary to completely overcome the adhesive. NOTE. The tweezers or needle nose pliers canmay be used in place of the screw driver.
[* black] Unplug the black and red speaker wires from the white outlet near the middle of the panel (purple marker) by gently pulling on the wires.

Изображение 2

Старая версия

Новая версия