Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Возврат к шагу #5

Редактировать с помощью Jamie Moore -

Правка одобрена автор David Hodson

Удален
Добавлено
Без изменений

Шаг Линий

[* black] A sticky adhesive holds the speakers in place in addition to the screws. The speakers will likely be reluctant to detach from the panel due to this cement.
[* icon_reminder] Before removing the speaker, unplug the black and red wires from the circuit board.
[*
black] To overcome the adhesive and remove the speakers, place one end of a pair of needle nose-pliers through a holePlace the screw driver in the screen on the backneedle hole of the speaker. Lever the pliers against the outside metalspeaker and push down on the plierslift up. This should be all that needs to be done to pop the speaker out. Before removing the speaker, unplug the black and red wires from the circuit board.
[* black] A good amount of force may be necessary to completely overcome the adhesive. Note:NOTE. The tweezers or needle nose pliers can be used in place of needle-nose pliersthe screw driver.
[* icon_reminder] Before removing the speaker, unplug the black and red wires from the circuit board.
[*
black] To overcome the adhesive and remove the speakers, place one end of a pair of needle nose-pliers through a holePlace the screw driver in the screen on the backneedle hole of the speaker. Lever the pliers against the outside metalspeaker and push down on the plierslift up. This should be all that needs to be done to pop the speaker out. Before removing the speaker, unplug the black and red wires from the circuit board.
[* black] A good amount of force may be necessary to completely overcome the adhesive. Note:NOTE. The tweezers or needle nose pliers can be used in place of needle-nose pliersthe screw driver.