Перейти к основному содержанию

Изменения к шагу №2

Отредактированно Jeff Suovanen -

Правка одобрена автор Jeff Suovanen

Удален
Добавлено
Без изменений

Шаг Линий

[* black] Gently pullicon_caution] Try to keep the battery adhesive tab away from the battery, toward the bottomstrips flat and unwrinkled during this procedure; wrinkled strips will stick together and break instead of the iPhone.
[* black
pulling out cleanly.
[* icon_caution
] To avoid tearing the adhesive strip, be careful not to pull against the battery or lower components.
[* black] Continue pulling, allowing theVery slowly, pull and stretch one adhesive strip to slowly slip outaway from between the battery andbattery, toward the rear case. Whenbottom of the iPhone.
[* black] Pull at as low of an angle as
you feel increased resistance fromcan without snagging the strip, stopadhesive strip on any of the components along the lower edge of the phone.
[* black] Don't press down on the battery as you pull the strip.
[* icon_note] The strip will stretch to many times its original length. Continue
pulling slowly until it releases and continue withslips out from underneath the next stepbattery.
[* black] Gently pullicon_caution] Try to keep the battery adhesive tab away from the battery, toward the bottomstrips flat and unwrinkled during this procedure; wrinkled strips will stick together and break instead of the iPhone.
[* black
pulling out cleanly.
[* icon_caution
] To avoid tearing the adhesive strip, be careful not to pull against the battery or lower components.
[* black] Continue pulling, allowing theVery slowly, pull and stretch one adhesive strip to slowly slip outaway from between the battery andbattery, toward the rear case. Whenbottom of the iPhone.
[* black] Pull at as low of an angle as
you feel increased resistance fromcan without snagging the strip, stopadhesive strip on any of the components along the lower edge of the phone.
[* black] Don't press down on the battery as you pull the strip.
[* icon_note] The strip will stretch to many times its original length. Continue
pulling slowly until it releases and continue withslips out from underneath the next stepbattery.
[* icon_note] If the battery adhesive tabs break during the removal process, use your fingers or blunt tweezers to retrieve the remaining length of adhesive, and continue pulling.
[* icon_caution] If any of the adhesive strips break underneath the battery and cannot be retrieved, try to remove the remaining strips, and then '''[guide|29424|proceed as instructed below|stepid=69623]'''.