Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #12

Редактировать с помощью Sam Goldheart -

Правка одобрена автор Sam Goldheart

До
После
Без изменений

Шаг Линий

[* black] Removered] Remove the following screws securing the logic board to the rear case:
[* red] Two 1.9
single 1.2 mm Phillips #000 screws
[* orange] One 2.3 mm standoff
screw
[* icon_note] Use a small flathead screwdriver to remove these standoff screws.
[* icon_reminder] During reassembly, you can use
securing the tip of a spudgerantenna interconnect cable to get the standoff screw startedlogic board.
[* black] Removered] Remove the following screws securing the logic board to the rear case:
[* red] Two 1.9
single 1.2 mm Phillips #000 screws
[* orange] One 2.3 mm standoff
screw
[* icon_note] Use a small flathead screwdriver to remove these standoff screws.
[* icon_reminder] During reassembly, you can use
securing the tip of a spudgerantenna interconnect cable to get the standoff screw startedlogic board.

Изображение 1

Старая версия

Новая версия