Перейти к основному содержанию

Возврат к шагу #1

Редактировать с помощью S Davies -

На одобрении

До
После
Без изменений

Шаг Линий

[* icon_note] In the following steps, you will use a heat gun to soften the adhesive securing the outer black border around the underside of the front glass panel to the inner case.
-[* black] With the heat gun set to low, start by heating the outer black border near the upper left corner of the glass panel.
+[* black] With the heat gun set to low, start by heating the outer black border near the upper left corner of the glass panel. Note: the underside, glass, and other metal parts will be hot to the touch. Be careful while handling!
[* black] Try not to excessively heat the outer plastic edge of the Evo.
[* icon_note] Due to the heat applied, it is normal for a layer of condensation to develop on the inside of the glass panel and/or the outside of the LCD. It can be removed with glass cleaner once the glass is separated from the display.