Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #1

Редактировать с помощью Yves -

Правка одобрена автор Claire Rapp

До
После
Без изменений

Шаг Линий

[* black] Lift up the ribbon cable and carefully peel away the black tape underneath, whichunderneath. It secures the SATA cable connector to the PCB of the hard drive. Failing to remove the tape will almost surely lead to pulling the cantilever contacts soldered to the flex cable from the connector housing, the retention force of the contacts in the housing is quite low.
[* black] Lift up the ribbon cable and carefully peel away the black tape underneath, whichunderneath. It secures the SATA cable connector to the PCB of the hard drive. Failing to remove the tape will almost surely lead to pulling the cantilever contacts soldered to the flex cable from the connector housing, the retention force of the contacts in the housing is quite low.
[* black] Pull the SATA cable connector straight out of the hard drive.
[* black] Carefully peel off the two black, square-shaped sticky pads (one visible in picture) from the corners of the hard drive, and stick them to your new hard drive in the same locations.